capt bob wrote:
Did you buy the one's from eBay that Kris posted? The listing says 24 LED's per ring.

capt bob wrote:
Babe and I have also ordered

can you please tell us how you mounted them without drilling holes

with photos

VmaxOZ told

I attached them simply by 3M double sided tape that comes with the lights
But I hat to remove the mesh to run the wire behind it and put it back again"

and this I do not understand

hammer wrote:
Those are el chepo rings Kirk. Dime a dozen on eBay. They look cheap without the plastic ring over the lights. The ones I posted do come with twice the amount of SMD's. You can see how many SMD's per ring in the photo below. You get what you pay for for sure

Thanks for the clarification Kris. I knew that there had to be a reason why they were so much cheaper.

vmaxbeast wrote:
John/Friede

1. take the scoops off the bike
2. Look inside the scoop and you will see that the 'mesh' has three tabs which penetrate through three holes and is bent back to hold it in place. ( when you take scoop off you will see what I mean)
3. You need to carefully straighten the mesh tabs so you can push the mesh out and remove it.
4. Then you run the two wires behind the mesh and put the mesh back in place and bend the tabs back to hold it in place again (be gentle o not to break the tabs)
5. Then use the tape to secure the rings to the mesh.

As an alternative you can drill a small hole in the mesh itself if you wish and run the wire through. Then cover the hole with the ring itself.
Many different applications really, so do what works for you guys

Here are some Night shots

Oh My God, Very nice.....Lets express our inner child.

That looks absolutely amazing Capt!!! But I am biased and like that look
They are very bright event against your flood lights. I guess you didn't get the bottom rings?
Piece of cake to install isn't it?

Glad it all worked out for you.
I am talking to Matt now about my retrofitting. Which should look good with the rings I hope

I gave you a good headlight shot Kris so it would tug at you a bit, riding will all that light is great i was out in the woods last night with the hi beam on and the halogens and the eyes it was really lighting up the turns the Intensifier is 3 times wider beam that the stock headlight light anyway and when you lean into turns it does the airplane wing thing with the cutoff line
in low beam mode, you will find the reflective road signs become very active cause the beam is so wide mine becomes a cobalt blue with the chromics and the eyes really light the front of the bike up very nice effect.

Funny riding the Causeways to Tampa drivers in the fast lane just move over i am sure they really dont know whats coming up behind them so quickly got a few thumbs up when passing and a few WTF's too.

I just ordered a set of the 80mm rings. Think they look great. Thanks, VmaxOZ, For finding and sharing these. I' still looking for some amber lights for the bottoms, for turn indicators. Maybe if these come in amber/yellow, like the back of the box seems to indicate, I can get some made by the same manufacturer.