I got my Harris Rear Wheel Stand, However, I don't think it's got the right hardware ? Taped to the handle were 2 adapters which were round,center-grooved wheels on square stock. If I put them on the stand with set screws--- which I didn't get, I don't see where they could go to lift the bike ! They said they would send the right articulation for a 2010 VMax-- Did They ?

Can you give us a picture of your setup?

Normally the "V" groove fits into the spools on the swingarm near the rear axle.

-Lee-

I agree with -Lee-. Those two wheels sound like the "spools" that get bolted to your swingarm. They are what the stand lifts the bike up with.

like this

Marks9222 wrote:


Here's the Harris Paddock Lifter on my 2009...

Hey Everybody ! THANKS, Your input and pictures really helped ! Looks like they sent nothing right and everything wrong ! I'll be making a call tomorrow and I've got the ammo to "Be All Over'em Like A Cheap Suit" Thanks, Marks9222

Hope they'll sent the right stuff for you.

Marks9222 wrote:


Make sure that they get Yamaha Part Number GYT-0SS56-10-01 (VMAX Rear Stand) and not just a Harris Rear Stand...

That part number was made for the 2009 V-Max...

A bike shop that I frequent has several Harris Rear Stands that they use in the shop and none of them will work on the 2009 V-Max...either they are too narrow or too high...

Just use that Part Number...